ZOSI 2.0MP 1080P HD 1920TVL Security Black CCTV Camera 80ft IR Night

Note: This is an Analog camera, it cannot be used alone, you need to connect an analog DVR, or a DVR compatible with the Analog camera, (it is compatible with any DVR currently sold by ZOSI)
1080P 4-in-1 Security Bullet Camera Security Camera Specification

 

This camera is recommended to work with a security DVR. This camera needs to be wired with bnc video cable and power cable. This item will not come with the cctv cable & power supply.

 

Image Sensor: 1/3〞CMOS CMOS with IR-Cut. Lens: 3.6mm Active Pixels: 1920(H)×1080(V). Singal mode: CVBS 960H / TVI / AHD / CVI. IR LEDs Amount: 24pcs, 5mm LEDs. IR Distance(night vision): up to 80FT Made: Aluminum Metal Casing Power supply: 12V 500mA 4-in-1 Security Dome Camera

Press OSD joystick to switch the output mode:

Default / Right for 5 seconds: CVBS 960H Down for 5 seconds: CVI Left for 5 seconds: AHD Up for 5 seconds: TVI

This 1080p full HD camera has a built-in OSD menu that can change the 4 different video outputs：

HD-TVI, AHD, CVI, and CVBS(960H)， and adjust the video settings.

Operation Mode：

Switch from AHD: Press Leftward for 5 Seconds

Switch from TVI: Press Rightward for 5 Seconds

Switch from CVBS: Press Upward for 5 Seconds

Switch from CVI: Press Downward for 5 Seconds

Noted: Default Video Mode is Analog 960H Mode

 

Advanced DWDR Technology

DWDR (Digital Wide Dynamic Range) technology automatically adjust the picture's brightness to let you see and capture a lot more details in a wide range of light conditions - from bright highlights to dark shadows.

1080p HD & 90° Angle View

With 2.0MP lens and 90° wide field of view, you can see everything clear and smooth in perfectly crisp 1080p HD with every subtle details. Get clearer and sharper images/videos than 720p cameras.

Enhanced Clarity with 3D-DNR

3D-DNR (Digital Noise Reduction) technology filters out digital noise from low-light scenes, as well as any noise caused by motion. By eliminating graininess, you can see more fluent image in better clarity, sharpness and get improved motion detection.

 

Troubleshooting

Q: Video Loss appears where the image from my camera should be displaying on my DVR?

A: 1.Check the extension cable (power and video) is securely connected to the camera.

2.Check the video output from the camera is securely connected to a video input channel on the DVR.

3.Check the power from the camera is securely connected to a power supply.

4. The camera mode do not match your DVR.there is 2 ways to setup . (1) Press OSD Joystick “DOWN” 5 seconds,if still no picture come, try to press “LEFT” “RIGHT””UP” for 5 second, till the signal matching your DVR. (2) Make sure the signal of your DVR, Use OSD Joystick to change the mode of the camera according to your DVRs video Mode.